ETQ DG6LE Owner's Manual download pdf (Page 18)

EASTERN TOOLS & EQUIPMENT INC Tele: (888)908-6200 Web Site: easterntools.com

3-1.1 Changing the engine oil (every 100 hours) 3-1.1 Changing the engine oil (every 100 hours)

Take the oil cover off. Remove the oil drain plug

when the diesel engine is still hot. Be careful of

hot oil and hot engine as you may get burned.

The bolt is located at the bottom of the cylinder.

After draining the oil, put the bolt back and tighten

it. Then fill with the proper engine oil to the

proper level.

Take the oil cover off. Remove the oil drain plug

when the diesel engine is still hot. Be careful of

hot oil and hot engine as you may get burned.

The bolt is located at the bottom of the cylinder.

After draining the oil, put the bolt back and tighten

it. Then fill with the proper engine oil to the

proper level.

3-1.2 Air filter maintenance schedule

(1) Clean air-filter every 6 months or 500 hours of

operation.

(2) If necessary, exchange it.

(3) Do not use detergent to clean air filter

element.

Note:

Never start the engine without the air filter.

This can cause serious damage to the

engine if foreign objects enter the intake

system. Always change the air filter on

time.

3-1.3 Fuel filter maintenance

(1) The fuel filter should be cleaned often to keep

the engine running at maximum performance.

High-pressure

fuel

e nut

Dipstick

(2) The recommended time period for cleaning

the fuel filter is 6 months or 500 hours of

operation.

a. To do this, first drain the fuel from the fuel

tank.

Oil drain bolt

b. Loosen the small screws on the fuel switch

and remove the fuel filter form the port.

Use diesel fuel to clean the fuel filter. Also,

remove the fuel injector and clean the

carbon deposit around it. The

recommended time period for this is 3

months or 100 hours.

3-1.4 Cylinder head bolt tensions

The cylinder head bolts should be tightened to

specifications please refer to the diesel engine

manual for specifications and the special tools

required to do this.

3-1.5 Battery check

Make sure the battery acid is full. The engine

uses a 12V battery. Due to numerous starting

cycles, the battery acid may be used up. Also,

before filling, verify that the battery is not

damaged in any way. Add distilled water to the

battery when filling. Perform checks on the

battery once a month.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Comments to this Manuals

No comments

ETQ DG6LE Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Power generators ETQ DG6LE